SMC Networks TigerSwitch manual Permit, deny MAC ACL, Syntax No permit deny

ACCESS CONTROL LIST COMMANDS

Command Usage

•When you create a new ACL or enter configuration mode for an existing ACL, use the permit or deny command to add new rules to the bottom of the list. To create an ACL, you must add at least one rule to the list.

•To remove a rule, use the no permit or no deny command followed by the exact text of a previously configured rule.

•An ACL can contain up to 32 rules.

Example

Console(config)#access-list mac jerry

Console(config-mac-acl)#

Related Commands

permit, deny (MAC ACL) (4-131) mac access-group(4-133)

show mac access-list(4-133)

permit, deny (MAC ACL)

This command adds a rule to a MAC ACL. The rule filters packets matching a specified MAC source or destination address (i.e., physical layer address), or Ethernet protocol type. Use the no form to remove a rule.

Syntax

[no] {permit deny}

{any host source source address-bitmask}

{any host destination destination address-bitmask} [vid vid [vid-end]] [ethertype protocol [protocol-end]]

Note:- The default is for Ethernet II packets.

•any – Any MAC source or destination address.

•host – A specific MAC address.

•source – Source MAC address.

•destination – Destination MAC address range with bitmask.

4-131