Appendix A – LED status patterns
The following table shows the different LED illumination combinations that can indicate possible error conditions.
In each case, the LEDs indicated will be on and steady, unless otherwise noted, and all other LEDs will be off. The Power and System LEDs are not part of the LEDs indicating status. Where the action indicates that you should contact your dealer, please note the LED pattern to assist with faster response and recovery action.
LED Pattern | Status | Action |
VPN | Memory failure. | Please contact your |
|
| dealer. |
COM2 | Console device cannot initialize. | Please contact your |
|
| dealer. |
All LEDs on | In recovery mode, usually from a bad Flash |
|
| image. While the reset button is held in this |
|
| will be the LED pattern. |
|
VPN &and Internet | Cannot load static data into memory, | Please contact your |
Link | probably memory and/or Flash problem. | dealer. |
COM2 and Internet | Cannot load SBSS, probably memory and/or | Please contact your |
Link | Flash problem. | dealer. |
Online | Memory exception. | Please contact your |
|
| dealer. |
95
Appendix A – LED status patterns
