Soehnle 7710 Error message Cause /Remedy / Information, Print-command conditions

English

Print-command conditions

The print templates are assigned to print-command conditions using the service software. The following conditions can be assigned to print templates:

•Print key

•Automatic print/data record once immediately

•Automatic print/data record once after weight change at standstill

•Automatic print/data record after weight change at standstill

•Automatic print/data record after weight change at standstill above the empty message

•Automatic print/data record after weight change at standstill above the empty message if the empty message was previously active.

•Continuous transmission

•Enter key for input from ORG A

•Enter key for input from ORG B

•Enter key for input from ORG C

•Enter key for input from ORG D

•Plus key (F key for totalising)

•Key combination INFO, F and Print key (setting-dependent)

•Enter key for manual input

•Print alibi memory

•Print reference statistics

	Error message			Cause /Remedy / Information
2		Ident chip error		For Customer Service for error diagnosis
	4	REF weight too small		Scale unsuitable for part weight, if applicable change set
				ting in setting mode
	5	Zeroing not possible		Deviation from zero point too great
	6 Taring not possible			Empty scale, scale in underload or overload, manual tare
				input with tare value above maximum load
	7	Not authorised to print
	8	No unit switchover
	9	Print signal buffer full
	10		Load cell signal overflow
	11 No measuring point signal
	12		Measuring point number ? CAN addr
	13		Converter failure
	15		Measuring point write-protected
	16		No measuring point detected
	18		Measuring point not zeroed
	20		Print format empty
	23		Print error
	24		Print template memory corrupt
	25		No print template(s)

52