Soehnle 7710 operating instructions English

English

	Error message		Cause /Remedy / Information
26		Printer update cancelled
	30	Alibi memory full
	33	Alibi memory contents corrupt
	34 Alibi memory empty
	35	No or defective alibi memory
	36	Cannot write alibi
	37 Alibi memory unreadable
	40	General data format error
	41	Input value too small
	42	Input value too big
	44	Power-off not allowed
	50	Value below zero range limit	Zeroing not possible because measured value is outside
			the set zero range limit
	51	Value above zero range limit	Zeroing not possible because measured value is outside
			the set zero range limit
	52	Overload	Measured value above weighing range
	53	Underload	Measured value below 0
	55	Position weight	Scale empty or no clip off has yet been set according to
			the set clip off factor.
	60	One Wire hardware error	For Customer Service for error diagnosis
	61	One Wire device absent	For Customer Service for error diagnosis
	62	One Wire protocol error	For Customer Service for error diagnosis
	63	One Wire CRC error	For Customer Service for error diagnosis
	64	Unknown family code found	For Customer Service for error diagnosis
	71	CAN input error	For Customer Service for error diagnosis
	72	CAN messages lost error	For Customer Service for error diagnosis
	73	CAN timeout error	For Customer Service for error diagnosis
	75	Replace backup battery
	80 Abort external command
	81 Timeout external command
	82	Number already exists	The identification assigned to a fixed value already exists
	88	System overload	For Customer Service for error diagnosis
	90	Fixed value memory assigned / full	A total of 400 memory locations are available and are
			valid for all programs.
	98	Wrong barcode
	99	Global error	For Customer Service for error diagnosis

53