Sony 7 manual Meters, Resetting clipping indicators, Scaling meters

Reset Clip

37

Meters

Meters display audio levels in a number of different places in Sound Forge: the Play Meters show audio file levels; meters in the Record dialog help you adjust levels for recording; and meters in the Wave Hammer® dialog help you adjust levels when applying this effect. Regardless of where the meters appear, you can control them in much the same way.

The full version of Sound Forge provides peak and VU/PPM (peak program) meters that you can use to monitor your audio levels.

The peak meters display instantaneous levels during playback to help you determine the loudest level in your audio signal and whether the signal is clipping.

Volume unit (VU) and peak program (PPM) meters help you determine the perceived loudness of your audio signal (peak program meters provide faster response times to volume increases than VU meters). VU/ PPM meters are especially helpful when you’re mastering: comparing two audio files’ VU/PPM readings will help take the guesswork out of matching levels.

VU/PPM readings should fall near the 0 (or reference) mark. 0 VU is merely a reference level, and your signal may exceed 0 VU. To prevent clipping, keep an eye on your peak meters. Peak levels should never exceed 0 dB. To accommodate louder or softer intensity material, you can use the Other tab in the Preferences dialog to calibrate the VU/PPM meters to their associated levels on the peak meters and adjust the VU meters’ sensitivity (to access the Preferences dialog, choose Preferences from the Options menu).

Resetting clipping indicators

When audio levels are too high, clipping can occur. A red indicator appears at the top of the meter to show

when audio is clipping. Click to reset the indicator, or right-click the meters and choosefrom the shortcut menu.

Clipping	Click the clipping
indicator	indicator to reset it.

You can also detect and mark clipped audio using the detect clipping tool. For more information, see Detecting and marking clipping on page 95.

Scaling meters

Meters can display a peak range and a VU (volume unit)/PPM (peak program) scale. To change the meter’s display levels, right-click the meter and do one of the following:

•Choose Peak Range from the shortcut menu, followed by the desired range from the submenu.

•Choose VU/PPM Scale from the shortcut menu, followed by the desired scale from the submenu.

VU and PPM scales are most useful for displaying the average volume of the signal: the meter represents the RMS average level during playback, and their attack and decay are not as sensitive as the peak meter.

CHP. 3 LEARNING THE SOUND FORGE WORKSPACE