SETTINGS OF CAMERA CONTROL AND STATUS REGISTER
CSR F0F00618h Memory Save
The current settings of the camera using commands CSR F0F00600h – F0F0060Ch, CSR F0F00620h, and CSR F0F00800hth are memorized in the Memory Channel specified by CSR F0F00620h.
The settings will be preserved in the memory even when the camera power is turned off.
Execute: Command = 80000000h
NOTE : 
Before setting Execute, set the CSR F0F00620h Memory Save Channel.
Memory Save requires about one second to execute. After setting, do not write other commands for one second.
CSR F0F0061Ch One Shot
Perform the isochronous transmission of images for only one frame.
Execute: Command = 80000000h
NOTE : 
Can be used only when CSR F0F00614h Iso_EN is OFF (STOP).
Do not set a new One Shot command until isochronous transmission completes after setting the One Shot command to CSR.
CSR F0F00620h Memory Save Channel
Specify the Memory Channel (ch1, ch2) for memorizing the current camera settings.
ch1: Command = 10000000h
ch2: Command = 20000000h
CSR F0F00624h Current Memory Channel
Read out the camera settings (ch1, ch2) memorized by the CSR F0F00618h Memory Save or the factory settings (Factory) from the memory, and set in the camera.
The Memory Channel that was specified last will be automatically memorized. When the power is turned ON the next time, the settings memorized in this Memory Channel will be effective.
ChannelCommand
Factory00000000h
ch110000000h
ch220000000h
23
