Playback and Recording 2 Chapter
13Press the SET (YES) button to confirm the defined value.
The message “NOW SAVING...” is displayed on the monitor screen and “Saving...” is shown in the time counter display while the new setting is being saved in memory.
Caution
The new setting may be lost if you power off the unit during the saving operation. Wait until the saving operation is completed before powering the unit off.
If you want to discard the changed value
Press the MENU button instead of pressing the SET (YES) button to return to the menu display, then press the MENU button again to end the menu operation without saving the changed value into memory.
After the saving operation is completed, the monitor screen and time counter display return to the REPEAT FUNCTION setting display as shown in step 9.
14To set point B, refer to steps 5 to 13. (Select “REPEAT END” in step 5, “B POINT” in step 7, and “B PRESET” in step 9.)
15Press the MENU button to close the menu.
Cuing Up to Any Desired Position Set as Point A or B
You can set any desired tape position as point A or B and cue up to the set point when required. To cue up to point A or B, holding down the g or G button in the menu control section, press the REW button in the tape transport control section.
For the methods of setting points A and B, see the previous section.
42 Playback