10-2 Setup Menu Operations

Menus Setup 10 Chapter

Resetting the menu settings to their factory default values (menu item B20)

To reset the current active menu settings to their factory default values, proceed as follows.

1Perform steps 1 to 3 of the procedure described in the section “To change the settings of menu items with sub-items” on page 10-3 to set menu item B20 RESET SETUP to ON.

The current active menu settings are reset to their factory default settings.

2Press the F5 (SET) button again. This saves the menu settings.

Switching the system frequency (menu item 013)

To switch the system frequency between 59.94i, 50i, 29.97PsF, 25PsF, 24PsF and 23.98PsF, proceed as follows.

Notes

•Before carrying out this operation, consult the person responsible for system installation.

•When the unit is used in 50i, 25PsF mode, analog tape can only be played back in the simple playback mode.

•When this unit is put into 24PsF or 23.98PsF mode, SDI (D1), component, and composite signals are not output.

1Perform steps 1 to 3 of the procedure described in the section “To change the settings of menu items with sub-items” on page 10-3 to set menu item 013 SYSTEM FREQUENCY SELECT to ON.

The menu display changes to allow switching of the system frequency between 59.94i, 50i, 29.97PsF, 25PsF, 24PsF and 23.98PsF.

2Switch the setting, then press the F5 (SET) button.

3Turn the unit off.

The next time the unit is turned on, it will operate in the new mode.

Switching the line conversion function (menu item 018)

This operation is valid in 59.94i and 29.97PsF mode only. It is not available in other mode.

To change the line conversion (OFF TAPE/1035/1080/ 720P), use the following procedure.

Notes

•Consult with the administrator responsible for system installation before carrying out the following procedure.

•For the setting of the line conversion (see next item, “Line conversion mode”), setup menu item 916 ACTIVE LINE 1035 CONVERT MODE is valid in 1035-line mode, and setup menu item 917 ACTIVE LINE 1080 CONVERT MODE is valid in 1080-line mode.

1Perform steps 1 to 3 of the procedure described in the section “To change the settings of menu items with sub-items” on page 10-3, to set setup menu item 018 ACTIVE LINE SELECT to ON.

The menu display changes to allow switching of the setting for line conversion between OFF TAPE, 1035, 1080, and 720P.

2Select OFF TAPE, 1035, 1080, or 720P, then press the F5 (SET) button.

3Turn the unit off.

The next time the unit is turned on, it will operate in the new mode.

10-4Chapter 10 Setup Menus