Sony HVR-Z1E manual 36

1 In the standby mode, press PICTURE PROFILE.

2 Select a picture profile number by turning the SEL/PUSH EXEC dial, then press the dial.

[PP1] through [PP6] are available.

3 Select [SETTING] by turning the SEL/ PUSH EXEC dial, then press the dial.

4 Select an item to be adjusted by turning the SEL/PUSH EXEC dial, then press the dial.

5 Adjust the picture quality by turning the SEL/PUSH EXEC dial, then press the dial.

Item	Adjustment
[COLOR	–7 (low) to +7 (high)
LEVEL]	–8: black and white
[COLOR	–7 (greenish) to +7 (reddish)
PHASE]
[SHARP-	0 (softer) to 15 (clearer)
NESS]

36Recording

Item	Adjustment
[SKINTONE	To make wrinkles less
DTL]	noticeable by suppressing the
	outlines on the part in skin color
	to be enhanced.
	[OFF]: No adjustment
	[TYPE1] (the color range
	recognized as a skin color is
	narrow) to [TYPE3] (the color
	range recognized as a skin color
	is wide)
[SKINTONE	Sets the enhancement level of
LVL]	the edge of the part in skin color
	for setting [SKINTONE DTL].
	[HIGH] (to enhance strongly) to
	[LOW] (to enhance weakly)
[AE SHIFT]	–7 (darker) to +7 (lighter)
[AGC	Select the upper limit for the
LIMIT]	auto gain control (AGC)
	([OFF], 12dB, 6dB, 0dB).
	[OFF] is 18dB.
[AT IRIS	Select the highest aperture
LMT]	value for the automatic
	adjustment (F11, F6.8, F4).
[WB SHIFT]	–7 (to make white parts bluish)
	to +7 (to make white parts
	reddish)
[ATW	To set the auto white balance
SENS]	operation under a reddish light
	source such as an incandescent
	lamp or candle, or under a
	blueish light source such as in
	outdoor shade.
	[HIGH] (reddishness or
	blueishness is reduced) to
	[LOW] (reddishness or
	blueishness is increased)
	[ATW SENS] is not effective
	under a clear sky or the sun.
[BLACK	[ON]: To raise the γ curve
STRTCH]	characteristics of the dark part
	so that the gradation of the dark
	part is reproduced better.