For customers in the U.S.A.

If you have any questions about this product, you may call:

Sony Customer Information Center 1-800-222- SONY (7669)

The number below is for the FCC related matters only.

Regulatory Information

Declaration of Conformity

Trade Name:

SONY

Model No.:

DCR-IP220

Responsible Party:

Sony Electronics Inc.

Address:

680 Kinderkamack

 

Road, Oradell,

 

NJ07649 U.S.A.

Telephone No.:

201-930-6972

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2)this device must accept any interference received, including interference that may cause undesired operation.

CAUTION

You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment.

Note:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

—Consult the dealer or an experienced radio/TV technician for help.

The supplied interface cable must be used with the equipment in order to comply with the limits for a digital device pursuant to Subpart B of Part 15 of FCC Rules.

DCR-IP220 only

 

IMPORTANT NOTEFor customers in CANADA

To comply with FCC RF exposure compliance

DCR-IP220 only

requirements, the following antenna

installation and device operating

The term “IC:” before the radio certification

configurations must be satisfied: the antenna

number only signifies that Industry Canada

has been installed by the manufacturer and no

technical specifications were met.

changes can be made.

 

This device and its antenna (s) must not be co-

 

located or operating in conjuctions with any

 

other antenna or transmitter.

 

3