Recording to MDs

This chapter explains the various ways to record to an MD, as well as how to mark track numbers and perform synchro-recording with other components. See also “System limitations” on page 47 before recording.

GB 14 Recording to an MD

Recording to an MD

If the MD has been partially recorded, recording starts after the recorded tracks.

?/1AMS

INPUT

OPEN/CLOSE A N X z

1Turn on the amplifier and program source, and select the source on the amplifier.

2Press ?/1 to turn on the deck.

The STANDBY indicator turns off.

3Press OPEN/CLOSE A to open the disc tray and insert a recordable MD.

To close the disc tray, press OPEN/CLOSE A again.

4Set INPUT to the position that corresponds to the input jacks (connector) connected to the program source.

When the source is connected to

Set INPUT to

the

 

 

 

DIGITAL IN OPT1 connector

OPT1

 

 

DIGITAL IN OPT2 connector

OPT2

 

 

DIGITAL IN COAXIAL jack

COAX

 

 

ANALOG IN jacks

ANALOG

 

 

5If necessary, locate the point on the MD to start recording from.

If you want to record to a new MD or start recording from the end of the recorded portion, skip this step and go to step 6.

To record over from the beginning of an existing

MD track

Turn AMS (or press ./> repeatedly) until the number of the track to be recorded over appears.

To record over from the middle of an MD track

Turn AMS (or press ./> repeatedly) until the

number of the track to be recorded over appears, then press Nto start play. Press Xat the point you want to start recording from.

6Press z.

The deck changes to recording pause.

7If necessary, adjust the recording level.

For details, see “Adjusting the recording level” on page 17.