Operations Advanced 6 Chapter
1
| 7 | 8 | 9 | |
M/E | EFF/ |
|
| |
WIPE |
|
| ||
|
|
| ||
| 4 | 5 | 6 | |
PP/ | SNAP |
|
| |
ALL | SHOT |
|
| |
| 1 | 2 | 3 | |
STORE | MCRO |
|
| |
| 0 | EFF | AUTO | |
BANK | DISS | TRNS | ||
TRANS | ||||
SEL | RATE |
|
|
2 | 3 | 4 |
1 Press the [SNAPSHOT] button, turning it on.
The button lights in amber, and the Flexi Pad control block enter snapshot operation mode.
Also, the numeric display shows the number of the bank selected last time, and the number of the register most recently recalled for the region.
2 If the [STORE] button is lit, press the button, turning it off.
3 Select the bank to recall.
See steps 4 and 5 of “Saving Snapshots” (page 125).
4 If you want to use a temporary attribute (see page 124), press one of the following buttons, selecting and lighting it.
M/E and PGM/PST
bus control block
Temporary attribute | Button pressed |
|
|
[XPT HOLD] button in M/E | |
| and PGM/PST |
| control blocks |
|
|
[XP/KY HOLD] button in | |
disable for key bus | AUX bus control block |
|
|
| |
bus |
|
|
|
Flexi Pad control block | |
|
|
Temporary attribute | Button pressed |
|
|
Effect dissolve | [EFF DISS] button |
|
|
Flexi Pad control block
Temporary attribute | Button pressed |
|
|
Auto transition | [AUTO TRNS] button |
|
|
See page 124 for the attributes which may be used .
Note
The
5 Press the memory recall button for the register where the snapshot that you want is saved (the button is lit in orange).
When the recall is complete, the pressed button lights in yellow.
The numeric display shows the bank number followed by the selected register number.
To maintainRecall the snapshot while holding down a
1 In the Flexi Pad control block, press the [STORE] button, turning it on.
2 While holding down the [SNAPSHOT] button, press the memory recall button for the snapshot that you want to delete.
The button goes out after the snapshot is deleted.
126 Snapshots