and Names 2 Chapter
BORD (border): When this button is on, you can add borders. The button lights in amber when no border parameters have been assigned to the knobs in the menu control block, and lights in green when they have been assigned.
SOFT (soft edges): When this button is on, you can add soft edges. The button lights in amber when no soft edge parameters have been assigned to the knobs in the menu control block, and lights in green when they have been assigned.
CROP button: When this button is on, you can perform cropping. The button lights in amber when no crop parameters have been assigned to the knobs in the
menu control block, and lights in green when they have been assigned.
N/R (normal/reverse): When this button is on, it lights in amber and the transition direction reverses every time a transition finishes.
REV: When this button is on, it lights in amber and the transition direction reverses.
POS (position) button: You can turn the positioner on and use the joystick to move effect patterns in the x- axis and
CTR (center) button: When the [POS] button is on, pressing this button returns an effect pattern to the default position and size.
Parts of Functions
ENABLE/UTILITY
EDIT | GPI | SAFE | 1 ENABLE/UTILITY operation buttons |
TITLE |
| ||
|
|
|
DEVICE/UTILITY
2 DEVICE/UTILITY operation buttons
DEV1 | DEV2 | PLAY | STOP | ALL | CUE | START | SHTL | JOG | |
STOP | TC | ||||||||
|
|
|
|
|
|
|
aENABLE/UTILITY operation buttons You can assign utility commands to these buttons.
The following utility commands are assigned by default. EDIT button: Enables and disables the switcher edit
mode.
GPI button: Enables and disables switcher GPI.
SAFE TITLE button: Turns on and off a marker showing the television reception safe area and a cross marker showing the center of the screen.
Blank button: No function assignment.
See “Utility Settings (Utility Menu)” (page 170) for more information about how to assign arbitrary utility commands to these buttons.
bDEVICE/UTILITY operation buttons You can assign utility commands to these buttons.
The following utility commands are assigned by default. DEV1/DEV2: Selects the Device1/Device2 as control
target.
PLAY: Plays a tape or disk.
STOP: Stops a tape or disk.
ALL STOP: Stops tapes or disks on all devices.
CUE: Cue up.
START TC: Sets the current timecode as the start point.
SHTL: Turns shuttle mode on and off.
JOG: Turns jog mode on and off.
Note
When a delegation selection button is on, turning the [SHTL] or [JOG] button on turns the delegation button off. (The button pressed later receives priority).
See “Utility Settings (Utility Menu)” (page 170) for more information about how to assign arbitrary utility commands to these buttons.
22 Control Panel Configuration