Macro Control Block | Menu Control Block |
MACRO
PRE POST ATTCH
MCRO MCRO ENBL
3 ATTCH ENBL button
2 POST MCRO button
1 PRE MCRO button
aPRE MCRO buttonUse this button to set a macro attachment in pre macro mode.
When you make settings in macro only mode, this button is used together with the Macro Only Set button, assigned to one of the buttons in the utility control block.
bPOST MCRO buttonUse this button to set a macro attachment in post macro mode.
When you make settings in macro only mode, this button is used together with the Macro Only Set button, assigned to one of the buttons in the utility control block.
cATTCH ENBL (attachment enable) buttonWhen this button is on, macro attachments assigned to buttons on the control panel are enabled.
1Top menu selection buttons Menu display
MENU
TOP/
SHUT
DOWN
REG
FILE
SET
UP
DIAG
2 Knobs
aTop menu selection buttonsSelect the menu shown in the menu display.
•TOP/SHUTDOWN (top menu/shutdown) button
•REG (register menu) button
•FILE (file menu) button
•SET UP (setup menu) button
•DIAG (diagnostics menu) button
bKnobsUse to adjust parameters shown in the menus.
Power Indicators, “Memory Stick” Slot, USB ConnectorA POWER B 1 Power A and B status indicators 2 “Memory Stick” status indicator
3“Memory Stick” slot
4 USB connector
aPower A and B status indicatorsTwo power supplies (A and B) can be installed in the control panel. When the control panel is powered on, the indicators corresponding to the installed power supplies light in green.
Parts of Functions and Names 2 Chapter
Control Panel Configuration | 23 |
|
|