Installing Software
This section describes how to install the software constituting the
To install software, use the Info/Install menu. In the Info/ Install menu, you can check the software version, or enter an installation key for each device.
To check the detail information for an application shown in the Version Information menu, use the Detail Information menu.
To display the Detail Information menu, from the top menu, select Setup/Diag >Info/Install >Detail Info.
Displaying Version Information (Version Information Menu)
To check the version of the application software (referred to as “applications”) currently installed in the devices constituting the
To display the Version Information menu, from the top menu, select Setup/Diag >Info/Install >Version Info.
The status area shows abbreviations for the applications and the version numbers.
If there are no communications with an application in the menu, the application box is grayed out. If the version information is not available, the [Version] box is left blank.
Abbreviations for applicationsAbbreviation | Name |
|
|
SWR | Switcher |
|
|
DME | DME |
|
|
PNL | Control panel |
|
|
MENU | Menu |
|
|
DCU | DCU |
|
|
The version information is shown as follows. V + version number + (Date)
E.g. V1.00 (Jul.01.2004) Version number: V1.00 Last updated: July 1, 2004
The abbreviation for the currently selected application appears on the [Target] button. The status area shows the name and version of the software/firmware constituting the currently selected application.
Note
No detail information is shown for applications not communicating with the menu application and applications for which version information was not available.
To change the application for which detail information is displayedPress the [Target] button.
When the popup window appears, press the button for the application for which you want to view the detail information.
The button names are the same as the application abbreviations (see “Abbreviations for applications”).
Manually Installing Software (Manual Install Menu)To install only the required software/firmware manually, use the Manual Install menu. Insert a “Memory Stick” on which the software has already been written.
Note
Install the DCU software separately from other software.
For details of software installation, refer to “Installing Software” in the Appendix (separate document).
1 From the top menu, select Setup/Diag >Info/Install >Manual Install.
Settings System 9 Chapter
Installing Software 161