Protective material | Shake the new developer cartridge 5 or 6 |
| times as shown. |
| Hold the developer cartridge firmly as shown below and shake |
| forward and back, left and right. |
| Remove the protective material after shaking the developer |
| cartridge. |
•The part of the developer cartridge shown in the next illustration is easily
deformed or damaged. Do not touch this part when handling the cartridge.
5 | • Do not touch the roller in the developer cartridge. If the roller is accidentally |
touched, image problems may result. In that case, replace the developer cartridge |
with a new cartridge.
• The seal must not be removed when shaking the new developer cartridge.
• Take care not to damage the developer cartridge when shaking it. If damaged, the developer in the cartridge may leak out.
Insert the new developer cartridge horizontally.
Insert the new developer cartridge in the same location as the cartridge that was removed.
6 | • Do not tilt the developer cartridge or insert it in the wrong direction or orientation. This may damage the developer |
| cartridge or drum cartridge and cause failure. |
•When inserting the developer cartridge, grasp it with both hands at the middle.
•Do not remove the seal from the developer cartridge until the cartridge is installed in the machine. If the seal is removed when the cartridge is not locked, the cartridge may fall out of the machine.
Insert with the arrow on the cartridge aligned with the arrow on the machine.
7
Detach the end of the seal from the developer cartridge.
Align the notch in the seal with the tab on the attachment part and pull up. Be careful not to completely remove the seal by pulling too hard.