MZ-E800

Note on Schematic Diagram:

All capacitors are in µF unless otherwise noted. pF: µµF 50 WV or less are not indicated except for electrolytics and tantalums.

All resistors are in and 1/4 W or less unless otherwise specified.

f : internal component.

C: panel designation.

A : B+ Line.

Power voltage is dc 1.5V and fed with regulated dc power supply from battery terminal.

Voltages and waveforms are dc with respect to ground in playback mode.

no mark : PLAYBACK

( ) : CHARGE

: Impossible to measure

Voltages are taken with a VOM (Input impedance 10 M). Voltage variations may be noted due to normal produc- tion tolerances.

Waveforms are taken with a oscilloscope.

Voltage variations may be noted due to normal produc- tion tolerances.

Circled numbers refer to waveforms.

*Replacement of IC801 used in this set requires a special tool. Therefore, it cannnot be replaced.

The voltage and waveform of CSP (chip size package) cannot be measured, because its lead layout is different form that of conventional IC.

6-7. SCHEMATIC DIAGRAM – MAIN Board (3/4) – • See page 37 for Waveforms.

(Page 32)

(Page 32)

(Page 32)

(Page 30)

(Page 36)

– 33 –

– 34 –

Page 26
Image 26
Sony MZ-E800 service manual Schematic Diagram Main Board 3/4 See page 37 for Waveforms