Sony MZ-N910 manual 81

Symptom	Cause/Remedy
The volume of the	• The track was recorded in analog mode (in digital mode, the
recorded track is	recording level is automatically set to the same level as that of the
low.	sound source). Or you used a connecting cord with an attenuator.
	, Use a correct connecting cord without an attenuator.
	• The recording level was low.
	, Adjust the recording level manually while recording (page 31).
Volume cannot be	• AVLS is on.
turned up.	, Release AVLS settings (page 64).
	• The “CUSTOM1” or “CUSTOM2” on “SOUND” settings are
	being applied.
	, This is not malfuntion. When either of these settings is applied,
	the maximum volume setting will be limited to a certain level
	(“VOL 24”) to prevent excessive loudness.
No sound comes	• The headphones/earphones plug is not firmly connected.
through the	, Plug in the plug of the headphones/earphones firmly to the
headphones/	remote control. Plug in the plug of the remote control firmly to
earphones.	i/LINE OUT.
	• The plug is dirty.
	, Clean the plug.
VOL + or –,	• The “AUDIO OUT” parameter is set to “LINE OUT”.
Virtual Surround,	, Set to “HeadPhone”.
or 6-Band
Equalizer does not
function or noise is
heard.
The volume from	• The “AUDIO OUT” parameter is set to “HeadPhone”.
connected speaker	, Set to “LINE OUT”.
or amplifier is low
(when analog
connection)
The volume from	• The “AUDIO OUT” parameter is set to “LINE OUT”.
the headphones/	, Set to “HeadPhone”.
earphones is too
loud.
The recorder skips	• The group skip is on.
several tracks	, The recorder returns to normal if no operation is made for 5
ahead or behind	seconds.
whenever you try
to fast forward or
rewind on the
recorder.
The edited tracks	• This occurs due to the MiniDisc system limitation. The
may exhibit sound	fragmentation of data may cause sound dropout while searching
dropout during	because the tracks are played in higher speed than normal
search operations.	playback.

81