Note

If you record on a previously recorded disc, the recorder is factory set to overwrite the entire contents of the disc. If you want the recording to start after the existing contents, do the procedure “Recording without overwriting existing material” (page 59) before doing step 3, “Record an MD.” (page 20).

To

Press

 

 

Record from the end of thePress END SEARCH, and then press and slide REC.1)
current contents1)

 

Record over previousPress N, or press ., or > to find the start point of
material from a pointrecording, and then press x to stop. Then press and slide
partway through1)REC.
PausePress X.2)

 

Press X again to resume recording.

 

 

Remove the MDPress x and open the lid.3) (The lid does not open while

 

“TOC Edit” flashing in the display.)

 

 

1)If “REC-Posi” is set to “From End”, recording operations will always start from the end of the previously recorded material without pressing the END SEARCH button (page 59).

2)A track mark is added at the point where you press X again to resume recording while pausing; thus the remainder of the track will be counted as a new track.

3)If you open the lid while “REC-Posi” is set to “From Here”, recording will begin from the top of the disc the next time you record. Check the point to start recording on the display.

If the recording does not start

Make sure the recorder is not locked (pages 12, 17).

Make sure the MD is not record-protected (pages 19, 74).

Premastered MDs cannot be recorded over.

To know the recording conditionThe REC LED lights up or flashes according to the recording condition.
RecordingREC LED
condition

 

 

 

While recordinglights up

 

flashes according

 

to the loudness of

 

the source while

 

recording with a

 

microphone

 

(voice mirror)

 

 

Recording standbyflashes

 

 

Less than 3flashes slowly
minutes’ recording

 

time available

 

 

 

A track mark hasgoes off
been added1)momentarily
While checking-outflashes faster

 

 

1)Except when track marking was done manually or automatically using Auto Time Mark (page 30).

21