Sony MZ-N910 While Editing

Symptom	Cause/Remedy
There is no R-	• There is no R-channel output if the cassette deck or an amplifier is
channel sound	connected with a monaural cord.
output when	, Make sure to use a stereo connecting cord. If, however, the
playing a track	connected equipment is monaural, there will be no R-channel
recorded from a
	sound output even with a stereo connecting cord.
cassette deck or
through an
amplifier, or when
listening to sound
from a cassette
deck or amplifier.

While Editing

Symptom	Cause/Remedy
The lid does not	• The power sources have been disconnected during recording or
open.	editing, or the battery have been exhausted.
	, Set the power sources again, or replace the exhausted battery
	with new ones.
Editing cannot be	• The power source has been disconnected or a power outage has
done.	occurred during editing.
	, The editing done to that point is not saved to the disc. Do the
	editing operation again.
You cannot erase a	• This is due to the MiniDisc system limitations. To erase a track that
track checked out	has been checked out from your computer, check it back in first,
from your	and then erase it using the SonicStage software.
computer.
Track marks	• This is due to the MiniDisc system limitations. When the data of a
cannot be erased.	track is fragmented, the track mark of a fragment under 12 seconds
	long (in SP stereo), 24 seconds long (in LP2 stereo mode or
	monaural mode), or 48 seconds long (in LP4 stereo mode) cannot
	be erased. You cannot combine tracks recorded in different
	recording modes, e.g., a track recorded in stereo and a track
	recorded in monaural; nor can you combine a track recorded with
	digital connection and a track recorded with analog connection.
The disc cannot	• The component does not support MDLP.
edit on other	, Edit on other component that support MDLP.
component.

82