Sony MZ-R5ST zVarious ways of playback, Playing an MD on the station, POWER, 20-EN, ACTIVE, SP LEVEL, Operation, Number keys, POWER p = (+, ACTIVE SP LEVEL

Keep pressing +

Press pand open the lid.2)

Press POWER

zVarious ways of playback

Playing an MD on the station

Play an MD with the recorder attached to the station as follows. You can use the card remote commander as well.

POWER p = (+				P
ACTIVE SP LEVEL
			POWER	POWER
	1	2	3
(	4	5	6
	7	8	9	+
			PLAY MODE
	>10	0/10
=			ACTIVE SP	ACTIVE
	= (		LEVEL
			+	SP LEVEL
	P	p
P				p
To			Operation
Play			Press (
Adjust the volume			Turn LEVEL on the
of the headphones			station
Pause			Press P
			Press Pagain to
			resume play
Find the beginning			Press =once
of the current track
Find the beginning			Press +once
of the next track

Go backwards while Keep pressing = playing1)

Go forward while playing1)

Remove the MD

Turn power off

1)To go backwards or forward quickly without listening, press Pthen keep pressing =or +.

2)Once you open the lid, the point to start play will change to the beginning of the first track.

Note

The power turns off automatically when you leave the station unoperated for 5 minutes during stop. Press POWER or (to turn the power on again.

Playing back with active speakers

You can enjoy MD playback on active speakers such as SRS-Z1000 (not supplied), etc., by connecting it to the station (page 35).

Operate with the buttons on the station or from the card remote commander.

To adjust volume

Press ACTIVE SP LEVEL –/+ on the station or the card remote commander.

Selecting a track directly (Direct Selection)

You can select a track directly by pressing the track number on the card remote commander.

1 Press the number key(s) for the track number of the track of your choice. The recorder will play the selected track.

		POWER
1	2	3

4 5 6 Number keys

7 8 9

PLAY MODE

>10 0/10

ACTIVE SP

=( +

LEVEL

Pp

z

•To select track number 10, press 0/10. •To select a track number larger than 10,

first press >10, then press the number for the tens digit and then the units digit. Press 0/10 if the units digit is zero.

•To select a track number larger than 100, first press >10 twice, then press the number for the hundreds digit, tens digit, and the units digit.

20-EN