Sony NSX-A959 manual Press CLOCK/TIMER once, then press II SET within 4 seconds, Press SLEEP

CLOCK

J ..–-–-–. . . . ... . ..-.l..–

1 Press CLOCK/TIMER once, then press II SET within 4 seconds.

The hour flashes.

When using the remote control

Press CLOCK, then press II SET within 4 seconds.

2 Press < DOWN or FF UP to designate the hour, and press 11 SET.

The hour stops flashing and the minute starts flashing.

3 Press + DOWN or * UP to designate the minute and press II SET.

The minute stops flashing on the display and the clock starts

from 00 second. -

To display the current time

Press CLOCIQTIMER once. The time is displayed for 4 seconds. However, the time cannot be displayed during recording.

To switch to the 24-hour standard

Press CLOCWTIMER once, then press ■ within 4 seconds.

Repeat the same procedure to restore the 12-hour standard.

If the clock display flashes

This is caused by a power interruption. The current time needs to be reset.

If power is interrupted for more than approximately 24 hours, all settings stored in memory after purchase need to be reset.

*MULTI JOG is also available instead of U and W. ENTER is also available instead of II SET.

The unit can be turned off automatically at a specified time.

Use the remote control.

7 Press SLEEP.

2 Within 4 seconds, press - or ~ to specify the time until the power is turned off.

Each time the button is pressed, the time changes between 5

and 240 minutes in 5-minute steps.

Specified time

To check the time remaining until the power is turned off

Press SLEEP once. The remaining time is displayed for 4

seconds.

To cancel the sleep timer

Press SLEEP twice so that “SLEEP oFF appears on the display.

‘MULTI JOG k also available instead of U and W.

21 ENGL/S/+