Sony NSX-A959 ‘“”=, Surround Speakers Jacks, Press VIDEO/AUX or MD, Play the connected equipment

CD DIGITAL OUT (OPTIONAL)

VIDEO/AUX IN MD

SURROUND SPEAKERS JACKS

Connect optional surround speakers with the 8 ohms to 16 ohms impedance to the jacks.

SURROUND SPEAKERS

LINE OUT

Refer to the operating instructions of the connected equipment for details.

●The connecting cords are not supplied. Obtain the necessary connecting cords.

●Consult your local Aiwa dealer for optional equipment.

This unit can input analog sound signals through these jacks. Use a cable with RCA phono plugs to connect audio equipment (turntables, LD players, VCRs, TV, MD players etc.).

Connect the red plug to R jack, and the white plug to L jack.

When connecting a turntable

Use an Aiwa turntable equipped with a built-in equalizer amplifier.

This jack is recommended to connect with an MD player. Use a cable with RCA phono plugs.

Connect the red plug to the MD R jack, and the white plug to the MD L jack.

●When MD player is connected to these jacks, no sound will be output from the LINE OUT jacks.

This unit can output analog sound signal through these jacks. Use a cable with RCA phono plugs to connect audio equipment with LINE IN (analog input) jacks.

m

Do not connect an equipment to LINE OUT and VIDEO/AUX IN simultaneously. Otherwise, noise is generated and malfunction occurs

This unit can output CD digital sound signals through this jack. Use an optical cable to connect digital audio equipment (digital amplifier, DAT deck, MD recorder, etc.).

Remove the dust cap @ from CD DIGITAL OUT (OPTICAL) jack. Then, connect an optical cable plug to CD DIGITAL OUT (OPTICAL) jack.

When the CD DIGITAL OUT (OPTICAL) jack is not being used

Attach the supplied dust cap.

23 ENGLISH

POWER 1 ‘“”=

u, *

To play equipment connected to VIDEO/AUX IN jacks or MD jacks, proceed as follows.

1 Press VIDEO/AUX or MD.

When an equipment connected to VI DEO/AUX IN jacks is

played: press VIDEO/AUX.

When an equipment connected to MD jacks is played: press MD.

2 Play the connected equipment.

To change a source name in the display

When VIDEO/AUX is pressed, VIDEO is displayed initially. It can be changed to AUX or TV.

With the power on, press POWER while pressing VIDEO/AUX. Repeat the procedure to select one of the names.

To adjust the sound level of the external source

When the sound level of the external source is much higher or much lower than that of other function sources, adjust it as follows.

1Press VIDEO/AUX or MD and play the equipment.

2Press ++ or -so that the sound level becomes the same as that of other function sources.

m

During recording, the sound level can not be adjusted.