8SENS (sensitivity) control knob

Used for manual iris adjustment in Absolute mode. This control is not operative when Relative mode is selected.

See the table “Iris adjustment functions”on page 11.

9COARSE control knob Used for manual iris adjustment.

See the table “Iris adjustment functions” on page 11.

0IRIS control

When the AUTO button is not lit, you can adjust the iris manually by turning the control.

When the AUTO button is lit, the reference value for automatic iris adjustment can be set with this control.

See the table “Iris adjustment functions” on page 11.

qa Iris gauge

Turn the gauge to set the line to the most frequently used iris position, and it can be used as the reference for manual iris adjustment.

qs AUTO button

Press and light the button to automatically adjust the iris according to the amount of input light.

When this button is lit, the reference value for automatic iris adjustment can be set with the iris control.

If you press the button when lit, it goes dark and manual iris adjustment is enabled.

Connector Panel

1MONITOR connector

2CCU/CAMERA connector

3EXT I/O connector

MONITOR

CCU/

EXT I/O

 

CAMERA

 

1MONITOR connector (BNC type) Connect to a video monitor.2CCU/CAMERA (camera control unit/camera) connector (10-pin)

Connect to the REMOTE connector of a camera control unit or a camera.

3EXT I/O (external input/output) connector (9-pin)

This connector permits you to control an external device using the PREVIEW button (page 6) or the preview switch (page 11).

Operational specifications

While the PREVIEW button or the preview switch (RCP-D50 only) is held pressed, pin 1 and pin 2 of the EXT I/O connector are short-circuited.

Pin assignment of the EXT I/O connector

51

9 6

Caution

When installing this panel, provide a gap of 7 cm (3 inches) or more behind the connector panel to prevent damage to cables.

13