Specifying the Security Codes

You can authorize specific persons to set the menu to Engineer mode, to operate this panel, and to adjust the iris and master black by specifying a security code.

Locking Engineer mode with a security code

1 Press the OTHERS button in the Menu operation block so that the OTHERS menu is displayed on the LCD, then press [RCP Config] to call the RCP Config menu.

2 Set the menu to Engineer mode.

1)Press [Security] on the RCP Config menu.

2)Press and highlight [Engineer Mode].

The [Status], [Menu Set], and [Code No.] buttons are displayed.

3 Press [Code No.].

The Security Code setting display appears.

4 Press [Enable].

The Security Code input display now appears and “Input New Code No.” is displayed.

5 Enter a security code and press [Enter].

Use [0] to [9] to enter the security code (up to 8 digits).

Asterisks, each representing one digit of the entered security code, are displayed in the upper New Code No. box.

Press [Back Space] to cancel previous input one at a time.

When you press [Enter], the message “Input Again to Confirm” is displayed.

6 Enter the security code again and press [Enter].

Asterisks, each representing one digit of the entered security code, are displayed in the lower New Code No. box.

If you enter an incorrect security code, the message “!!!Code No. NG!!!” is displayed.

When you enter the correct security code, the Security Code setting display is resumed with highlighted [Enable] and additional [Code Change].

After this setting, the Security Code input display appears when you press [Engineer Mode] of the Security menu.

Releasing the security code lock of Engineer mode

1 When a security code for Engineer mode has been set, operate in the same manner as step 1 through step 4 in “Locking Engineer mode with a security code.”

The Security Code input display appears.

2 Enter the security code and press [Enter].

The security code lock is released.

Locking panel operations, iris/master black adjustments menu with a security code (Panel Active Lock)

1 Press the OTHERS button in the Menu operation block so that the OTHERS menu is displayed on the LCD, then press [RCP Config] to call the RCP Config menu.

2 Set the menu to Engineer mode.

1)Press [Security] on the RCP Config menu.

2)Press and highlight [Engineer Mode].

The [Status], [Menu Set], and [Code No.] buttons are displayed.

3 Press [Status].

The Security Status menu appears.

4 Press B to display the second page and press [Enable].

49