Initial Settings
The Security Code input display appears. (Pressing [Enable $ENG Code%] registers the same security code as Engineer mode for Panel Active Lock.)
5 Operate in the same manner as step 5 and step 6 in “Locking Engineer mode with a security code.”
The Security Status menu is resumed with highlighted [Enable] and additional [Code Change].
After this setting, when you hold the PANEL ACTIVE button pressed for more than 2 seconds, the message “!!Panel Locked!!” is displayed and the panel is locked.
When the panel is locked, the Security Code input display appears when you press the PANEL ACTIVE or IRIS/M. BLACK ACTIVE button.
If the correct security code is not entered, the lock is not released.
Notes
•If no security code has been set for Engineer mode,
[Enable $ENG Code%] is not displayed.
•When the panel is locked with a security code, the panel lock is not released even when power to this unit is shut off.
The panel lock is released when you select Engineer mode.
•When the panel is locked with a security code, only Security from RCP Config can be selected in the OTHERS menu.
•If you specify a security code only for Panel Active Lock without setting a security code for Engineer mode, Engineer mode is also locked with the security code for Panel Active Lock when the panel is locked.
Disabling the security code for Panel Active Lock
1 When Panel Active Lock has been enabled, operate in the same manner as step 1 through step 3 in “Locking panel operations, iris/master black adjustments menu with a security code (Panel Active Lock).”
The Security Code input display appears.
2 Press B to display the second page and press [Disable].
The security code is disabled.
Changing a security code
1 Press [Code Change] on the Security Code setting display.
The Security Code input display appears and the message “Input Old Code No.” is displayed.
2 Enter the current security code and press [Enter].
Asterisks, each representing one digit of the entered security code, are displayed in the Old Code No. box.
When you press [Enter], the message “Input New Code No.” is displayed.
3 Enter a new security code and press [Enter].
The message “Input Again to Confirm” is displayed.
4 Enter the new security code again and press [Enter].
The new security code becomes valid.
Note
If no security code has been set, [Code Change] is not displayed.
If you forget the specified security code(s)
1 Shut down power to the unit, then reapply power while holding the MASTER and CLOSE buttons pressed.
The confirmation display for canceling the securing code appears.
2 Press [OK].
The message “Code No. cleared” is displayed, and the security code settings are canceled.
50