Initial Settings
Adjusting the Brightness/
Contrast of the LCD
You can adjust the brightness and contrast of the display of the menu control block.
Proceed as follows:
1 Press [LCD] on the OTHERS menu to display the LCD setting display.
Clear | Exit |
LCD Brightness
/Contrast
Bright Cont
5 5
2 Adjust Bright and Cont (5 is the standard value with both items).
To adjust the brightness and contrast for camera pictures
1 Press [LCD Moni.] on the OTHERS menu to display the LCD setting display.
2 Adjust Bright and Cont (5 is the standard value with both items).
When the adjustment is completed
Press [Exit] to leave the menu.
Assigning a Function to the
ASSIGN Button
You can assign a function to the ASSIGN button. Note that the assignable functions depend on the connected camera.
Proceed as follows:
1 Press the OTHERS button in the Menu operation block so that the OTHERS menu is displayed on the LCD, then press [RCP Config] to call the RCP Config menu.
2 Set the menu to Advanced Setting mode.
1)Press [Security] on the RCP Config menu.
2)Press and highlight [Engineer Mode].
The [Status], [Menu Set], and [Code No.] buttons are displayed.
3)Press [Status].
The Security Status menu appears.
4)Press [Advance Mode].
3 Press [SW Setting] on the RCP Config menu to obtain the SW Setting display.
RCP Config Menu | Exit | |
SW Setting | ||
|
SW Assign
NoAssign
Black/Flare
BlackAUTO
ATW
TLCS
DynaLatitude
Sel
4 Turn the second left control knob (Sel) to highlight the function to be assigned.
NoAssign (default): No assignment
Black/Flare: Switching the function of the BLACK/FLARE knobs
Black AUTO: ON/OFF of the auto black
ATW: ON/OFF of the auto tracing white balance
TLCS: ON/OFF of the total level control function
DynaLatitude: ON/OFF of the DynaLatitude function
Note
Some functions may be unoperative, depending on the connected camera.
When the assignment is completed
Press [Exit] to leave the menu.
48