Sony HCD-T1 Inserting the batteries, Setting the Clock, 12,3,4, To correct the clock setting

Inserting the batteries

Insert two R6 (size AA) batteries into the supplied remote.

Setting the Clock

You need to set the clock before using the timer function. The clock shows the time in the 24-hour cycle.

GB

6

Battery life

You can expect the remote to operate for about six months using Sony SUM-3 (NS) batteries before the batteries run down. When the batteries no longer operate the remote, replace both batteries with new ones.

To avoid battery leakage

If you are not going to use the remote for a long time, remove the batteries to avoid damage caused by corrosion from battery leakage.

1 2,3,4

ENTER

1 Press TIMER SET.

2 Press TIMER+ or – to display “CLOCK” and press ENTER.

The hour indication begins flashing.

0 0�0

3 Set the current hour by pressing TIMER+ or – and press ENTER.

The minute indication begins flashing.

8 1 0

4 Set the current minute by pressing TIMER+ or – and press ENTER. The clock starts operating.

To correct the clock setting

Repeat steps 1 to 4.

About the time indication

•The built-in clock shows the time in the display when you press POWER to turn off the power.

•The upper dot of the “:” in the time display flashes for the 0 to 29 seconds of the minute and the lower dot flashes for the 30 to 59 seconds.

Chapter 1: Setting up