
CAUTION
For safety, do not connect the connector for peripheral device wiring that might have excessive voltage to this port. Follow the instructions for this port.
|
| Note |
|
|
| If the power of the projector remains on for a long period | |
|
| of time without the ethernet cable connected, the message | |
| |||
| |||
| |||
|
| “Sony Data Projector Initializing…” may appear in the | |
| |||
| |||
| |||
|
| STATUS MESSAGE window while you are setting up for | |
Chapter |
| ||
| a malfunction of the projector. | ||
|
| networking after connecting the ethernet cable. This is not | |
2 |
|
|
|
Preparations |
|
|
|
| Connecting the Computer via the | ||
|
| ||
|
|
|
INTER LOCK ETHERNET | RS232C |
RS232C connector
Connecting cable (not supplied)
Computer
Starting the SRX Controller
icon for the SRX Controller in the desktop window of the computer.
The SRX Controller starts and the Program Launcher screen is displayed.
Note when starting the SRX Controller
When the Operating System of the computer is Windows XP SP2 or later, or any commercially available firewall software is installed in your computer, the following may occur. In these cases, unblock the Windows firewall following the procedures below.
For Windows XP SP2 or later
If the dialog shown below appears when the SRX Controller is started, select “Unblock”. When the dialog does not appear but the computer does not access the projector, start “Windows Firewall” from “Control Panel”, and then add “SRX Controller” to the list in the “Exceptions” tab.
For commercially available firewall software Add “SRX Controller” to the Exceptions list, referring to the operating instructions supplied with the software.
18 Starting the SRX Controller