Controller SRX the Using Settings and Adjustments 4 Chapter

6500K: White (0.3127, 0.3290)

9300K: White (0.2840, 0.2970)

DCI W/P: White (0.3140, 0.3510)

CUSTOM1 to CUSTOM3: White (0.3127, 0.3290) (default values)

Gamma settings 2.6: 2.6

2.2: 2.2

CUSTOM: Value set using CUSTOM

Frame Adjust

Adjusts the horizontal size and the position of the picture.

Clicking increases the setting value, and decreases it.

Clicking the “RESET” button resets all the settings of “Frame Adjust” to the factory-preset values.

Dot Phase: Adjusts the phase of the SXRD panels and the input signal. Adjust the value to obtain the clearest picture.

H Size: Adjusts the horizontal size of the picture according to the input signal. As the setting value increases, the horizontal size of the picture becomes larger.

H Shift: Adjusts the horizontal position of the picture. As the setting value increases, the picture moves to the right. As the value decreases, the picture moves to the left.

V Shift: Adjusts the vertical position of the picture. As the setting value increases, the picture moves up. As the value decreases, the picture moves down.

Notes

•Adjustment of “Dot Phase” and “H Size” is available only for analog RGB signals input from a computer.

•If the position of the picture is not adjusted correctly, noise may appear in the blank portion of the screen. This is not a malfunction of the projector. Adjust the picture position correctly with “Frame Adjust”.

INSTALLATION Window

The INSTALLATION window is used to adjust the projected picture and to change the lamp output, etc.

LENS CONTROL

Adjusts the projected picture on the screen.

Zoom +/–:Adjusts the size of the picture. Clicking

enlarges the picture size, and reduces the picture size.

Focus +/–:Adjusts the picture focus. Clicking focuses

on a picture further back. Clicking focuses on a forward picture.

Shift +/–:Adjusts the vertical position of the picture. Clicking moves the picture upward. Clicking moves it downward.

ELECTRIC V SHIFT FUNCTION

Adjusts the vertical position of the projected pictures electrically. As the setting value increases, the picture moves upward. As the setting value decreases, the picture moves downward.

Clicking the “RESET” button resets the setting to the factory-preset values.

Notes

•This function is effective in the following cases:

-When single-screen mode is selected

-When quad-screen mode is selected and “PROGRESSIVE DISPLAY MODE” is set to “On”

•When this function is used for quad-screen mode, all the projected signals should be genlocked to synchronize with each other with a phase difference of less than 5 µsec. If they are not synchronized, the picture is not displayed correctly.

30 INSTALLATION Window