Sony SRX-T105, SRX-T110 Projecting, Using the Remote Commander, Projecting the Picture

Projecting

Projecting the Picture

Chapter	Use the supplied Remote Commander or a computer in
3
	which the supplied SRX Controller is installed to project
Projecting
	the picture on the screen.

Using the Remote Commander

1 STATUS LAMP indicator

					1
					2
SCREEN			1	I	3
MODE
			MUTING
1	2	4			MUTING
			FUNCTION
	1		2	3
			INPUT SEL		5
	A		B C	D
		PICTURE CONT
	+		+	+
CONTR			BRIGHT	SHARP
	–		–	–
			SCREEN SEL
	1			2
	3			4
			LENS CONT		7
	+		+	+	9
FOCUS			ZOOM	SHIFT
	–		–	–
					6, 8

SR Projector

RM-PJ4K IR

Chapter3

1 Set the main power switch on the left side of the projector to the upper position.

The STATUS LAMP indicator lights red and the projector goes into standby mode.

2 Press the ? button to turn on the projector.

The STATUS LAMP indicator lights green.

3 Select the screen mode.

Each time you press the SCREEN MODE button, the screen mode switches as follows:

1(single-screen mode): Projects an image in single screen.

2(dual-screen mode): Projects images in two divided

screens.

4(quad-screen mode): Projects images in four divided screens.

When you select the dual-screen mode or quad-screen mode, you can also project a different input source in each screen.

4 Turn on the equipment connected to the projector.

5 Press the INPUT SEL button to select the input source.

A:Selects the signal input from the connectors on the pre-installed input board in the INPUT A section.

B:Selects the signal input from the connectors on the optional input board installed in the INPUT B section.

C:Selects the signal input from the connectors on the optional input board installed in the INPUT C section.

D:Selects the signal input from the connectors on the optional input board installed in the INPUT D section.

When you select dual-screen mode or quad- screen mode in step 3

Press one of the INPUT SEL A to D buttons to select the input source you want to project, then select one of

22 Projecting the Picture