Overview 1 Chapter
Location: Shows the installation location of the projector that was set in the SETTING window.
Name: Shows the name of the projector that was set in the SETTING window.
Operation Timer: Shows the total operating hours of the projector.
Lamp A/Lamp B: Shows an approximate percentage to indicate the time used before the recommended time for replacement of each projection lamp (i.e. 100% indicates the time for replacement). The indicator on the left lights when the corresponding lamp turns on. It does not light when the corresponding lamp turns off.
Warning Info: Displays an error message if there is any warning information on the projector. The same message is displayed in the STATUS MESSAGE window on the left side of the projector.
dPOWER ON/STANDBY (?/1) buttons and
POWER indicator
Click “ON” to turn on the lamp. The indicator lights green. Clicking “STANDBY” opens the confirmation dialog. Clicking “OK” makes the projector enter standby mode. The indicator flashes green. Even in standby mode, the fans continue to run to reduce internal heat. When the fans stop running, the indicator lights red.
eFUNCTION 1 to 7 radio buttons
Register the data set or adjusted in the Control Function Menu windows to these buttons, and recall it later to project an image with that setting.
The setting items that can be registered are as follows:
•Screen mode and input signal settings in the SCREEN CONTROL window
•“Input Source” and “Signal Adjust” settings in the PICTURE CONTROL window
•“Color” settings in the COLOR/FRAME window
•“ELECTRIC V SHIFT FUNCTION”, “SQUEEZE”, “PROGRESSIVE DISPLAY MODE”, “LAMP POWER” and “LAMP SELECT” settings, and “LENS CONTROL” settings when the optional lens equipped with zoom/focus memory function is installed, in the INSTALLATION window
For details, see “To register the settings that have been adjusted” on page 26.
fWindow select buttons
Open the window with the items you want to set or adjust.
gAdjustment/setting window
Clicking the window select button switches the window for the adjustment and setting.
The PICTURE CONTROL, COLOR/FRAME and INSTALLATION windows can be displayed.
For details on each window, see “Adjustments and Settings Using the SRX Controller” on page 26.
SCREEN CONTROL window1 | 2 | 3 | 4 | 5 | ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
aScreen mode buttons
Select 
for
for 
for quad- screen mode.
bCUT OFF ON/OFF buttons
Click the “ON” button to cut off the picture momentarily. Click the “OFF” button to restore the picture.
The SCREEN CONTROL window changes depending on the screen mode selected with the screen mode button (1). When dual- or
cInput signal select
Selects the input signal you want to project on the screen. The SCREEN CONTROL window changes depending on the screen mode selected with the screen mode button (1). When dual- or
the
the optional input board installed in the INPUT B section.
INPUT C: Selects the signal input from the connectors on the optional input board installed in the INPUT C section.
INPUT D: Selects the signal input from the connectors on the optional input board installed in the INPUT D section.
dMUTING ON/OFF buttons
Clicking the “ON” button cuts off the whole picture on the screen momentarily. Click the “OFF” button to restore the picture. Activating the muting function blocks off lamp light completely by use of a shutter, and displays the black signal on the whole screen.
eOSD ON/OFF buttons
Click the “OFF” button to eliminate the
10 Location and Function of Controls