
SIRCS
Sets to enable or disable operations using the remote commander.
To enable operations, press the “On” radio button. To disable operations, press the “Off” radio button.
IMAGE FLIP
Flips the picture.
Select it from the according to the installed condition of the projector.
Off: Normal projection
H:Flips the picture horizontally
V:Flips the picture vertically
HV: Flips the picture horizontally and vertically
OffH
V | HV |
PROGRESSIVE DISPLAY MODE
Normally, click the “Off” radio button.
Click the “On” radio button when the signals from four input boards are used to project a 2048 (1920) × 1080 pixels signal as a 4096 (3840) × 2160 pixels 4K image or to project a 1400 × 1050 pixels (SXGA+) signal as a 2800 × 2100 pixels image in
SQUEEZE
This function allows the input signal to be displayed on the screen in a converted aspect ratio.
When you click the “On” radio button, the following input signals can be displayed on the screen by horizontal stretching.
•Video 50 Hz or Video 59.94 Hz signal with a 4:3 aspect ratio: Stretched to a 16:9 aspect ratio.
•720p, 1920 × 1080 or 2048 × 1080 signal with a 16:9 aspect ratio: Stretched to a 2.39:1 aspect ratio.
When you click the “Off” radio button, the input signal is displayed without converting the aspect ratio.
Note
This function is available only for projection in single- screen mode.
LAMP POWER
Adjusts the lamp power output.
Select it from the
.
You can reduce the lamp power to 93%, 86%, 79%, 72%, 65%, 58% or 51%. Selecting “100%” allows you to obtain the brightest projection image.
Note
Switching the lamp output frequently may reduce the lamp life. Use of the defined lamp output is recommended.
LAMP SELECT
Selects whether to use one of two lamps or both lamps.
Dual: Select when using two lamps.
Single: Select when using only one of two lamps.
In Single, you can further select the lamp to be used automatically or manually.
Auto Lamp Select Mode
When you click the “Full Auto Select” radio button, the lamp with fewer used hours is automatically turned on. When you use the projector for a long period of time, click the
clicking the /
buttons, the two lamps turn on alternately at the interval of the specified hours.
Manual Lamp Select Mode
You can specify the lamp to be used by clicking the “Lamp A” or “Lamp B” radio button.
Note
If you switch “LAMP SELECT” from “Single” to “Dual” or when either Lamp A or Lamp B switches to turn on, the projected image will be cut off momentarily (up to 10 seconds).
Controller SRX the Using Settings and Adjustments 4 Chapter
INSTALLATION Window 31