About the items that cannot be adjusted

Items that cannot be adjusted depending on the input signal are not displayed in the window.

For details, see “Input Signals And Adjustable/Setting Items” on page 33.

PICTURE CONTROL Window

The PICTURE CONTROL window is used to select the input source or to adjust the picture quality.

When the screen mode is set to dual-screen mode or quad- screen mode, the items can be independently adjusted for each input channel displayed on the screen.

Board

Shows the input board installed in the relative input board slot of the projector.

Input Source

Signal Mode: Click to open the drop-down list to select the type of signal input from equipment connected to the optional input board.

When the LKRI-004 or LKRI-005 is installed Select the input signal type of progressive DVI-D signals.

When used in normal, select “8bit Single Full”, which is compatible with DVI1.0 standard and the signal level is Full Range compliance.

When the DTV signal is input, select “8bit Single Limited”, which is compatible with DVI1.0 standard and the signal level is Limited Range compliance. When the 10-bit signal based on Sony’s unique specification is input, select “10bit Twin Full” or “10bit Single Full” for a signal of Full Range

Controller SRX the Using Settings and Adjustments 4 Chapter

PICTURE CONTROL Window 27