Rotate FUNCTION to select TUNER. The last received station is tuned in.

Preset tuning

After you have tuned in stations using Direct Tuning or Automatic Tuning, you can preset them to the receiver. Then you can tune in any of the stations directly by entering its

2-character preset code using the supplied remote. Up to 30 FM or AM stations can be preset. The receiver will also scan all the stations that you have preset.

Before tuning to preset stations, be sure to preset them by performing steps on “Presetting radio stations”.

Presetting radio stations

1

2 Tune in the station that you want to preset using Direct Tuning (page 44) or Automatic Tuning (page 44).

3 Press MEMORY.

“MEMORY” appears in the display for a few seconds.

Do steps 4 to 5 before “MEMORY” goes out.

4 Press PRESET TUNING + or PRESET TUNING – to select a preset number.

If “MEMORY” goes out before you press the preset number, start again from step 3.

5 Press MEMORY again to store the station.

If “MEMORY” goes out before you can store the station, start again from step 3.

6 Repeat steps 2 to 5 to preset another station.

Tuning to preset stations

You can tune the preset stations by either of the following two ways.

Scanning the preset stations

1 Rotate FUNCTION to select TUNER.

The last received station is tuned in.

2 Press PRESET TUNING + or PRESET

TUNING – repeatedly to select the preset station you want.

Each time you press the button, the receiver tunes in one preset station at a time, in the corresponding order and direction as follows:

nA1˜A2˜...˜A0˜B1˜B2˜...˜B0N

nC0˜...C2˜C1N

Using the preset codes

Use the supplied remote to perform the following operations. For details on the buttons used in this section, see page 63.

1 Rotate FUNCTION to select TUNER.

The last received station is tuned in.

2 Select the preset station you want from the list displayed on the supplied remote.

Broadcasts Receiving

45