To change the button assignments

You can change the factory settings of the function buttons to suit the components in your system. For example, if you connect a LD player to the VIDEO 2 jacks on the receiver, you can set the VIDEO2 button on this remote to control the LD player.

Note, however, that the settings of the TUNER button cannot be changed.

1 Press USE MODE for more than 2 seconds.

The indicator remains lit.

2 Press the function button you want to change the assignment of.

The indicator turns off when a valid button is pressed. Only the first function button that is pressed will be registered.

Example: Press VIDEO2.

3 Press the function button for which you want to change the assignment to.

See the table below for the factory assigned categories of each button. To select “2nd pressed” or “3rd pressed” categories, press the same button twice or three times. The indicator turns off when a valid button is pressed.

Example: Press DVD/LD twice.

4 Press SOURCE.

The new assignment is registered.

The indicator slowly lights up twice, then goes off.

Tip

If the operation is unsuccessful, the indicator flashes twice and the remote automatically exits the button assignment mode. In this case, the new assignment is not registered and the previous setting remains.

Notes

•If you do not press a button during step 2 through 4 within thirty seconds, the remote automatically exits the button assignment mode. Start again from step 1.

•In step 3, if you press the same button more than the possible number of categories that can be selected, only the last category is registered for the new assignment.

•In step 3, if you press several function buttons, the category of the last pressed button is selected.

Valid buttons and the corresponding categories

 

 

Categories*

 

Button

1st pressed

2nd pressed

3rd pressed

 

 

 

 

VIDEO1

VTR1

VTR4

—

 

 

 

 

VIDEO2

VTR2

VTR5

—

 

 

 

 

VIDEO3

VTR3

VTR6

—

 

 

 

 

DVD/LD

DVD player

LD player

—

 

 

 

 

TV/SAT

TV

SAT

—

 

 

 

 

TAPE

Tape deck A

Tape deck B

—

 

 

 

MD/DAT MD deck

DAT deck

—

 

 

 

CD/SACD CD player 1

CD player 2

CD player 3

*To assign to VIDEO CD, press VIDEO 1 first, then press CD/SACD.

using Operations remote the

81