Specifications (continued)
FM tuner section
Tuning range | 87.5 - 108.0 MHz |
Antenna terminals | 75 ohms, unbalanced |
Sensitivity |
|
Mono: | 18.3 dBf, 2.2 µV/75 ohms |
Stereo: | 38.3 dBf, 22.5 µV/75 ohms |
Usable sensitivity | 11.2 dBf, 1 µV/75 ohms |
S/N |
|
Mono: | 76 dB |
Stereo: | 70 dB |
Harmonic distortion at 1 kHz | |
Mono: | 0.3% |
Stereo: | 0.5% |
Separation | 45 dB at 1 kHz |
Frequency response | 30 Hz – 15 kHz, |
| |
Selectivity | 60 dB at 400 kHz |
AM tuner section
Tuning range
With
With | 531 – 1710 kHz4) |
Antenna | Loop antenna |
Usable sensitivity | 50 dB/m (at 1,000 kHz or |
| 999 kHz) |
S/N | 54 dB (at 50 mV/m) |
Harmonic distortion | 0.5 % (50 mV/m, |
| 400 Hz) |
Selectivity |
|
At 9 kHz: | 35 dB |
At 10 kHz: | 40 dB |
4)You can change the AM tuning scale to 9 kHz or 10 kHz. After tuning in any AM station, turn off the receiver. Hold down TUNING + and press ?/1. All preset stations will be erased when you change the tuning scale. To reset the scale to
10 kHz (or 9 kHz), repeat the procedure.
Video section
Inputs |
|
Video: | 1 |
Y: 1 | |
| C: 0.286 |
Outputs |
|
Video: | 1 |
Y: 1 | |
86 | C: 0.286 |
Remote control
Remote control system
| Infrared control |
Power requirements | 4.5 V DC with three LR6 |
| |
| batteries |
Dimensions | 175 ⋅ 62 ⋅ 33 mm |
Mass (approx.) | 135 g excluding batteries |
Remote control
Remote control system
| Infrared control |
Power requirements | 3 V DC with two R6 |
| |
Dimensions | 210 ⋅ 45 ⋅ 25 mm |
Mass (approx.) | 95 g excluding batteries |
General |
|
Power requirements | 120 V AC, 60 Hz |
Power consumption |
|
Models of area code U |
|
420 W | |
410 W | |
Models of area code CA |
|
470 W | |
450 W |
Power consumption (during standby mode)
| 1 W |
AC outlets | 2 switched, 120 W/1A |
Dimensions | 430 ⋅ 174 ⋅ 465 mm |
| including projecting parts |
| and controls |
Mass (Approx.) |
|
20.0 kg | |
20.0 kg |
Supplied accessories FM wire antenna (1) AM loop antenna (1) Audio/video/control S cord (1) Control S cord (mini jack) (1)
Remote commander
LR6
For details on the area code of the component you are using, see page 4.
Design and specifications are subject to change without notice.