4SHIFT button

When the tuner is selected, press repeatedly to select a memory page for presetting radio stations or tuning to preset stations.

5MUTING button*

The function of this button is same as the MUTING button on the receiver. See page 27.

6MASTER VOL +/– buttons*

Press to adjust the volume level of all speakers at the same time.

7MULTI/2CH A. DIRECT button

The function of this button is same as the MULTI/2CH ANALOG DIRECT button on the receiver. See page 27.

8MODE +/– buttons

The function of this button is same as the MODE +/– buttons on the receiver. See page 31.

9PRESET button

Press to select CINEMA STUDIO A–C or

D.CONCERT HALL A, B.

0CH/PRESET/D.SKIP/+/– buttons**

Press repeatedly to select a preset station or channel. When using a multi-disc changer, press to skip a disc.

qa Operation buttons**

The following table describes the function of the buttons.

Button(s) Function

NStarts play. (Starts play on the front side of the cassette.)

nStarts play on the reverse side of the cassette.

XPauses play or recording, and starts recording when the component is in recording standby.

xStops play.

./> Skips tracks.

m/M Fast forwards or rewinds.

qsUSE MODE button

Press to change the mode of the remote or to change the category of the buttons.

qdUSE MODE indicator

*These buttons operate receivers with COMMAND MODE set to “AV SYSTEM1” or other Sony receivers.

**The function of these buttons switches

automatically each time you press the function buttons (3). The above explanation is intended to serve as an example only. Therefore, depending on the component, the above operation may not be possible or may operate differently than described.

Tip

To clear all programmed signals, press ?/1 and USE MODE at the same time. The remote is reset to its factory-setting.

To switch the command mode of the remote

When operating the STR-DA5ES, set the same command mode to the remote and the STR-DA5ES.

When controlling Sony receivers in the 2nd room

Switch to AV SYSTEM 1. You can switch sources on the receiver.

1 Press USE MODE.

The current remote mode button slowly lights up 5 times. The default setting is “AV SYSTEM 1”.

2 Press AV SYSTEM 1 or AV SYSTEM 2 while the button blinks.

The command mode has been changed.

Tips

•Each time you press a function button or other operation buttons on the remote, the current remote mode button lights up.

•You can switch the remote mode temporarily. For example, when set to AV SYSTEM 1, if you press CD/SACD while holding down AV SYSTEM 2, the signal for AV SYSTEM 2 mode is output.

continued

using Operations remote the

79