Adjustments using the SET UP button (continued)

x2-way remote (2 WAY REMOTE)

(STR-DA5ES only) This receiver is shipped from the factory with the 2 way remote control system set to “ON”. Normally, you can use the receiver as is. However, if you want to use this receiver together with another component that is also compatible with the 2 way remote control system, be sure to perform the following operation to limit response to signals sent from the remote controls.

First select one component for the 2 way remote control, then set the 2 way remote control system for the component to “ON”. For other components, set the 2 way remote control system to “OFF”. With these settings, the component for which the 2 way remote control system is set to “OFF” cannot be used. Therefore, connect the CONTROL A1 jacks of both components with monaural (2P) mini- plug cord.

xSelecting the command mode of the remote (COMMAND MODE)

Lets you select the command mode of the remote. Change the command mode when you use 2 Sony receivers in the same room.

xTest tone mode (T.TONE)

Lets you select the test tone output mode (page 25).

•“NORMAL” output the test tone from each speaker in sequence.

•“PHASE NOISE” output the test tone from two adjacent speakers at a time in sequence.

•“PHASE AUDIO” output the source sound instead of the test tone from two adjacent speakers at a time in sequence.

xColor of the on-screen display (OSD)

Lets you select the color of the on-screen

display.

xOSD horizontal position (OSD

H.POSITION)

Lets you adjust the position of the on-screen display horizontally.

xOSD vertical position (OSD

V.POSITION)

Lets you adjust the position of the on-screen display vertically.

50