Using the lists (continued)
Learning the commands of your components
By using the Learning function, it is possible for this commander to perform learned operations.
Setting remote control codes that are not stored in the commander
When a remote control code is not one of the presets stored in the commander, it is possible for the commander to learn the code using the Learning function.
1 Press SET UP and move the easy scroll key to select “LEARNING”, then press the key to enter the selection.
The function list appears.
<LEARNING> [VIDEO 1 ]
p[VIDEO 2 ] [VIDEO 3 ]
2 Move the easy scroll key to select the function you want to use the Learning function, then press the key to enter the selection.
The button list appears.
[VIDEO 2 ]
*POWER p REVERSE
*PLAY
3 Move the easy scroll key to select the button you want to use for the Learning function, then press the key to enter the selection.
The learning display appears.
[VIDEO 2 ] |
|
|
| Function |
|
| |||
(REVERSE) |
|
|
| Button |
|
|
| ||
p Learning Start |
|
|
|
|
Cancel |
|
|
|
|
|
|
|
|
|
4 Point the remote code receiver section of the commander toward the receiver/ transmitter on the remote control to be learned.
|
| – | m | . | X | h |
|
– | + | + | M | > | x | H | ?/1 |
About 5 cm – 15 cm
5 Move the easy scroll key to select “Learning Start”, then press the key to enter the selection.
“Learning Now!!” is displayed.
6 Press the appropriate button on the remote control to send the remote control code.
Lightly pressing the button once should be sufficient. In about 3 to 5 seconds, it is displayed whether learning was successful or not.
When the learning completes successfully, “Learning OK!”, the number of keys, and the capacity used for learning are displayed.
[VIDEO 2 ]
x(REVERSE) Learning OK! (15/80 20%)
When the learning does not complete successfully, the cause is displayed.
Learning NG! |
|
(REVERSE) |
|
FULL (Keys) | Information* |
pExit
*FULL (Keys): shortage of buttons
FULL (memory): shortage of memory
ERROR: other causes
68