The source sound input from the HDMI jack is not output from an amplifier or the TV speaker connected to the receiver.
•Check that the component is connected correctly to the HDMI jack for that component.
•The sound is not output when you display the receiver’s menu on the TV monitor. Press AMP MENU to turn off the display.
•You can listen to the Super Audio CD on HDMI only by linear PCM signal transmission.
•Depending on the playback component, component may need to be set up. Refer to the operating instructions supplied with the each component.
•Be sure to use a connecting cable for the HDMI jack corresponding to high speed (an HDMI version1.3a, category 2 cable) when you view images or listen to sound during a DeepColor transmission.
The left and right sounds are unbalanced or reversed.
•Check that the speakers and components are connected correctly and securely.
•Adjust the balance parameters using the Auto Calibration settings menu.
There is severe hum or noise.
•Check that the speakers and components are connected securely.
•Check that the connecting cords are away from a transformer or motor, and at least 3 meters (10 feet) away from a TV set or fluorescent light.
•Move your TV away from the audio components.
•Make sure you have grounded the U SIGNAL GND terminal (only when a turntable is connected).
•The plugs and jacks are dirty. Wipe them with a cloth slightly moistened with alcohol.
There is no sound, or only a very low- level sound is heard from the center/ surround/surround back speakers.
•Select a “Cinema Studio EX” mode (page 64).
•Adjust the speaker level (page 71).
•Make sure the center/surround speaker (s) is (are) set to either “SMALL” or “LARGE” (page 72).
There is no sound from the surround back speakers.
•Some discs have no Dolby Digital Surround EX flag even though the packages have Dolby Digital Surround EX logos. In this case, select “ON” in the “SB Dec Mode” (page 69).
There is no sound from the sub woofer.
•Check that the sub woofer is connected correctly and securely.
•Make sure you have turned on your speaker.
•When all speakers are set to “LARGE” and “Neo:6 Cinema,” or “Neo:6 Music” is selected, there is no sound from the sub woofer.
The surround effect cannot be |
| ||
obtained. |
| ||
• Make sure the sound field function is on |
| ||
(press MOVIE or MUSIC). |
| ||
• Sound fields do not function for signals |
| ||
with a sampling frequency of more than 48 | Additional | ||
sound is not reproduced. | |||
kHz. |
| ||
Dolby Digital or DTS |
| ||
• Check that the DVD, etc. you are playing | Information | ||
is recorded in Dolby Digital or DTS | |||
| |||
format. |
| ||
• When connecting the DVD player, etc., to |
| ||
the digital input jacks of this receiver, |
| ||
make sure the setting for the digital audio |
| ||
output of the connected component is |
| ||
available. |
| ||
continued |
|
| |
|
| ||
125GB