(aerial), ground it against lightning. To prevent a gas explosion, do not connect the ground (earth) wire to a gas pipe.
Outdoor FM antenna (aerial)
Receiver
Ground (earth) wire (not supplied)
To ground
Radio stations cannot be tuned in.
•Check that the antennas (aerials) are connected securely. Adjust the antennas (aerials) and connect an external antenna (aerial), if necessary.
•Keep the satellite radio antenna, away from the speaker cords and the power cord to avoid picking up noise.
•The signal strength of the stations is too weak (when tuning in with automatic tuning). Use direct tuning.
•Make sure you set the tuning interval correctly (when tuning in AM stations with direct tuning).
•No stations have been preset or the preset stations have been cleared (when tuning by scanning preset stations). Preset the stations (page 81).
•Press DISPLAY so that the frequency appears on the display.
The system cannot receive satellite channels at all.
•The receiving condition is not good. Move the antenna to the place where the condition is good.
•Check that you subscribed to the desired satellite radio service (see page 82).
The remote does not function.
•Point the remote at the remote sensor on the receiver.
•Remove any obstacles in the path between the remote and the receiver.
•Replace all the batteries in the remote with new ones, if they are weak.
•Make sure that the command modes of the receiver and the remote are the same. If the command mode of the receiver and the remote are different, you cannot operate the receiver with the remote (page 37).
•Make sure you select the correct input on the remote.
•When you operate a programmed non- Sony component, the remote may not function properly depending on the model and the maker of the component.
Error messagesIf there is a malfunction, the display shows a code of two numbers and a message. You can check the condition of the system by the message. Refer to the following table to solve the problem. If any problem persists, consult your nearest Sony dealer.
PROTECTOR |
| |
| ||
Irregular current is output to the speakers, or |
| |
the upper panel of the receiver is covered | Additional | |
with something. The receiver will | ||
| ||
automatically turn off after a few seconds. |
| |
Check the connection of speakers and turn |
| |
on the power again. | Information | |
For other messages, refer to “Message list after | ||
| ||
auto calibration measurement” (page 48), |
| |
“XM Radio message list” (page 89), “SIRIUS |
| |
Satellite Radio message list” (page 89) and |
| |
“DIGITAL MEDIA PORT message list” |
| |
(page 94). |
|
continued
127GB