Confirming/saving the measurement results

1 Confirm the measurement result.

When the measurement ends, a beep sounds and the measurement result appears on the TV screen.

Note

When the speaker(s) is (are) out of the phase, “Out Phase” is displayed on the TV screen. The “+” and “–” terminals of the speaker may be connected the other way around. However, depending on the speakers, “Out Phase” appears on the TV screen even though the speakers are connected properly. This is because of the speakers’ specifications. In this case, you can continue to use the receiver.

Tip

The displayed unit of distance for models for US and Canada is feet. The unit of distance for models for countries/areas other than US and Canada is meters. You can change the unit of distance use in “Distance Unit” in the Speaker settings menu.

2 Press to select “Next.”

When “Save auto calibration (auto speaker setup) results?” appears on the TV screen, you can select whether to confirm the warning (“Yes”) or not (“No”).

Follow the instructions of the TV screen when you select “Yes.”

For details on warning and error codes, see “Message list after auto calibration measurement” (page 48).

Tip

Press on the remote when “Please Press ENTER.” appears on the TV screen.

3 Press B/b repeatedly to select “Yes,” then press .

4 Press V/v repeatedly to select the auto calibration type, then press b.

The measurement results are saved.

Parameter

Explanation

Full Flat

Makes the measurement of

 

frequency from each

 

speaker flat.

 

 

Engineer

Sets the frequency to one

 

that matches that of the

 

Sony listening room

 

standard.

 

 

Front Reference

Adjusts the characteristics

 

of all the speakers to match

 

the characteristics of the

 

front speaker.

 

 

OFF

Sets the auto calibration EQ

 

to off.

 

 

5 Press .

The exit screen appears.

46GB