14" | S E R V I C E | For Machines Mfg. Since 5/11 |
|
|
|
Figures 117–121 show the location of the adjustment screws for each gib on this machine.
Compound Rest
Gib Adjustment Screw
(1 of 2) 
Cross Slide
Gib Adjustment Screw
(1 of 2)
Figure 117. Compound and cross slide gib adjustment
screws.
Saddle Rear
Gib Adjustment
Screw (1 of 2)
Figure 118. One of two rear saddle gib adjustment
screws.
Gib Adjustment
Screw (1 of 2)
Figure 119. Front saddle gib adjustment screw.
Note: Remove the thread dial body and the carriage lock clamp to access the saddle gib adjustment screw on the tailstock side (see Figure 120).
Carriage
Lock
Clamp
Figure 120. Carriage lock clamp.
Note: Before adjusting the tailstock gib, loosen the clamping hex bolts underneath both ends of the tailstock (see Figure 121) to release the clamping pressure between the upper and lower castings. Test the gib adjustment by using the offset adjustment screws. When you are satisfied with the setting, retighten the clamping hex bolts.
