14" | M A I N T E N A N C E | For Machines Mfg. Since 5/11 |
|
|
|
The following recommended lubrication schedules are based on
Failure to follow reasonable lubrication practices as instructed in this manual could lead to premature failure of lathe components and will void the warranty.
Lubrication
Headstock
Oil Type... Mobil DTE Light or ISO 32 Equivalent
Oil Amount | 7.4 Quarts |
Check/Add Frequency | Daily |
Change Frequency | Every 6 Months |
The headstock gearing is lubricated by an oil bath that distributes the lubricant with the motion of the gears, much like an automotive manual transmission.
Checking Oil Level
The headstock reservoir has the proper amount of oil when the oil level in the sight glass is approximately halfway. The oil sight glass is located on the right side of the headstock, as shown in Figure 100.
Headstock
Oil Sight
Glass
Figure 100. Location of headstock oil sight glass.
Adding Oil
The oil fill plug is located on top of the headstock, as shown in Figure 101.
Fill
Plug
Drain
Plug
Figure 101. Headstock fill and drain plugs. |
|
Changing Oil |
|
Items Needed | Qty |
Wrench 5⁄8" | 1 |
Catch Pan 2 Gallon | 1 |
To change the headstock oil:
1.DISCONNECT LATHE FROM POWER!
2.Remove the end gear cover.
3.Remove the
4.Remove the fill plug on top of the headstock to allow the oil to drain more freely.
5.Place the catch pan under the headstock drain plug (see Figure 101), then remove the plug.
6.When the headstock reservoir is empty, replace the drain plug and clean away any oil that may have spilled.
7.Fill the headstock reservoir until the oil level is approximately halfway in the sight glass.
8.Replace and
