For Machines Mfg. Since 5/11 | P R E P A R A T I O N | 14" |
|
|
|
In addition to the reservoirs, we also recommend that you lubricate all other points on the machine at this time. This can be accomplished by following the maintenance schedule on Page 64.
Note: If this lathe was shipped with oil in the reservoirs, do not change that oil until after the test run and spindle
To connect the power cord to the lathe:
1.Make sure the master power switch is turned to the OFF position, then open the electrical cabinet door.
2.
Adding Coolant
Add the coolant of your choice now. For detailed instructions on where the coolant tank is located and how to add fluid, refer to Coolant System Service on Page 71.
Power Connection
Electrocution or fire may occur if machine is ungrounded, incorrectly connected to power, or connected to an undersized circuit. Use an electrician or a qualified service personnel to ensure a safe power connection.
Once your machine is set up and assembled as previously described in this manual, it is ready to be connected to the power source.
Note About Extension Cords: Using an incorrectly sized extension cord may decrease the life of electrical components on your machine. Refer to Extension Cords on Page 18 for more information.
Note About
Incoming
Power
Strain
ReliefMaster
Power
Switch
Figure 21. Location to connect power inside main
electrical cabinet.
3.Connect the incoming hot wires to the upper master power switch terminals, as illustrated in Figure 22.
To Plug |
| Ground |
|
| |
|
| Gn |
Hot | Hot | Hot |
1 3 5
MASTER
POWER SWITCH
2 4 6
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| L1 |
| L2 |
| L3 |
|
| |||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
