![](/images/new-backgrounds/1332075/332075151x1.webp)
14" | M A I N T E N A N C E | For Machines Mfg. Since 5/11 |
|
|
|
End Gears
Grease Type. | .............................................. NLGI#2 |
Frequency | Annually or When Changing |
The end gears, shown in Figure 110, should always have a thin coat of heavy grease to minimize corrosion, noise, and wear. Wipe away excess grease that could be thrown onto the
Figure 110. End gears.
Handling & Care
Make sure to clean and lubricate any gears you install or change. Be very careful during handling and
Make sure the end gear cover remains installed whenever possible to keep the gears free of dust or debris from the outside environment.
Lubricating
1.DISCONNECT LATHE FROM POWER!
2.Remove the end gear cover and all the end gears shown in Figure 110.
3.Clean the end gears thoroughly with mineral spirits to remove the old grease. Use a small brush if necessary to clean between the teeth.
4.Clean the shafts, and wipe away any grease splatters in the vicinity and on the inside of the end gear cover.
5.Using a clean brush, apply a thin layer of grease on the gears. Make sure to get grease between the gear teeth, but do not fill the teeth valleys.
6.Install the end gears and mesh them together with an approximate 0.002" backlash. Once the gears are meshed together, apply a small dab of grease between them where they mesh together— this grease will be distributed when the gears rotate and
7.