For Machines Mfg. Since 5/11 | O P E R A T I O N | 14" |
|
|
|
To mount a non-concentric workpiece to the faceplate:
1.DISCONNECT LATHE FROM POWER!
2.Protect the bedway with a piece of plywood.
3.With help from another person or a holding device to support the workpiece, position it onto the faceplate and clamp it in place with a minimum of three independent clamping devices (see Figure 38 for an example).
Be sure to take into account the rotational and cutting forces that will be applied to the workpiece when clamping it to the faceplate. If necessary, use
Workpiece 
Clamp
Faceplate
Figure 38. Example photo of workpiece clamped in a
faceplate.
Tailstock
The tailstock (see Figure 39) is typically used to support long workpieces by means of a live or dead center (refer to Centers on Page 41). It can also be used to hold a drill or chuck to bore holes in the center of a part. Custom arbors and tapers can also be cut on your lathe by using the offset tailstock adjustment.
Quill Lock | Tailstock Lock Lever |
Lever |
|
Quill
Handwheel
Figure 39. Tailstock and quill lock levers in locked
position.
Graduated Dial |
|
|
Increments | 0.001" | |
One Full Revolution | .......................................0.100" | |
Increments on Quill | ||
Inch | ||
Metric | ||
Positioning Tailstock
1.Pull the tailstock lock lever backward (away from the spindle) to unlock the tailstock from the bedway.
2.Slide the tailstock to the desired position.
3.Push the tailstock lock lever forward (toward the spindle) to lock the tailstock against the bedway.
Using Quill
1.Move the quill lock lever toward the spindle to unlock the quill.
2.Turn the quill handwheel clockwise to move the quill toward the spindle or counterclockwise to move it away from it.
3.Move the lock lever away from the spindle to secure the quill in place.
