For Machines Mfg. Since 5/11 | S E R V I C E | 14" |
|
|
|
5.Remove the pedal stop shown in Figure 126.
Pedal Lever
Brake Belt
Band
Pedal Stop 
Figure 126. Brake belt adjustment components.
6.Move the brake band to the right one hole, and
Note: If installing a new brake band, install the cap screw so there is one hole to the left for future brake adjustment.
7.Firmly push the pedal lever to the right until it stops and the brake band is fully clamped around the brake hub.
8.Tap the pedal stop into position so there is approximately a 25mm gap between the pedal lever and the stop (see Figure 127), then firmly tighten the pedal stop cap screw.
Pedal |
| Pedal | ||
Stop |
| Lever | ||
|
|
|
|
|
Figure 127. Brake pedal travel adjustment.
9.Locate the brake switch shown in Figure 128.
Brake
Switch
Pedal
Cam
Figure 128. Brake switch and pedal cam.
10.Push the pedal lever down to verify that the cam lobe pushes the brake switch plunger in. When pushed in, the switch should click.
—If the switch does not click, loosen the switch mounting screws, push the brake pedal all the way down, and move the switch closer to the lobe until it clicks. Secure the switch in place at this location.
Note: In the released position, there should be an approximate 3mm gap between the switch plunger and the cam lobe.
11.
