Position and Level the Tumbler
Remove lint panel door, and unscrew the four shipping bolts (one at each corner). Remove tumbler from skid.
NOTE: Do not throw bolts away – they are the leveling legs.
Remove four nuts from the literature packet and screw one fully onto each leveling leg.
Screw the four leveling legs (bolts) back into the level adjusting fittings from the bottom.
Slide tumbler to its permanent location. Adjust the leveling legs until the unit is level within 1/8 inch
(32 mm). Tumbler must not rock. Lock leveling legs with nuts previously installed.
IMPORTANT: Keep tumbler as close to floor as possible. The unit must rest firmly on floor so weight of tumbler is evenly distributed.
T483I
T483I
Figure 2
Installation
Installing Accessory Timing Cam
Metered Models
Coin drop tumblers have eight accessory cams in the literature packet. These allow you to change your vending times. Refer to Table 1. Timer motor RPM is printed on the timer motor.
Cam Pins | 1/30 RPM | 1/60 RPM | |
Timer Motor | Timer Motor | ||
| |||
|
|
| |
2 | 15 | 30 | |
|
|
| |
3 | 10 | 20 | |
|
|
| |
4 | 7.5 | 15 | |
|
|
| |
5 | 6 | 12 | |
|
|
| |
6 | 5 | 10 | |
|
|
| |
8 | 3.75 | 7.5 | |
|
|
| |
10 | 3 | 6 | |
|
|
| |
12 | 2.5 | 5 | |
|
|
|
Table 1
70256801 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | 17 |